The short version of Chromatogram fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-01-07. Anything still debated is marked as such rather than presented as settled.
Routine quality control uses system suitability, blank injections, check standards, and control samples to detect drift or contamination. System suitability criteria may specify minimum resolution, maximum tailing factor, and a permitted range for repeated injections. Blank injections reveal carryover or solvent contamination, while check standards confirm calibration accuracy over a batch. Control samples with known analyte levels can show whether results remain within statistical limits. When a control result falls outside limits, the analyst investigates the cause and may invalidate affected results before repeating the batch.
Documentation and traceability are central to regulated HPLC testing. Records typically include instrument logs, column history, mobile-phase preparation, sample preparation, injection sequences, raw chromatograms, and audit trails. Electronic systems may require user access controls, time-stamped changes, and backup procedures. Training records show that analysts are qualified for assigned methods. Audits and inspections check whether written procedures match actual practice and whether deviations are documented. These controls support reproducibility and allow results to be reconstructed if questions arise later.
High-performance liquid chromatography is an analytical technique that separates components in a liquid sample. A pump moves a liquid mobile phase through a column packed with a solid stationary phase. Compounds interact differently with both phases and travel at different rates, leaving the column at distinct retention times. A detector records these arrivals as peaks on a chromatogram. The resulting pattern supports identification and quantification of substances in mixtures. Modern instruments use high pressure to force solvent through small particles, which improves speed and resolution compared with older low-pressure liquid chromatography methods.
Separation in HPLC depends on the chemistry of the stationary phase, the composition of the mobile phase, and the physical properties of the column. Reverse-phase separations use a nonpolar stationary phase and a polar mobile phase, and they are common for many organic compounds. Ion-exchange, size-exclusion, and normal-phase modes serve other classes of analytes. Gradient elution changes solvent strength over time, while isocratic elution holds it constant. Flow rate, temperature, particle size, and column length all influence peak shape and resolution. Detection may use ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry, depending on the analyte and the required sensitivity.
Routine HPLC testing compares a sample result with a calibration curve prepared from known reference standards. Peak area or peak height is plotted against concentration, and the curve is used to estimate unknown amounts. Retention time supports tentative identification when compared with a standard, though mass spectrometry or another confirmatory method may be needed for definitive identification. Pre-run checks verify repeatability, resolution, and peak symmetry before sample analysis. Limits of detection and quantification describe the smallest amounts that can be reliably observed or measured. Sample preparation, filtration, and degassing help prevent column damage and inconsistent results.
| Property | Value | Notes |
|---|---|---|
| Accuracy | Recovery near 100% | Depends on acceptance criteria and matrix |
| Precision | Relative standard deviation | Often at or below 2% for replicate injections |
| Limit of detection | Signal-to-noise ratio 3:1 | Approximate and method-specific |
| Limit of quantitation | Signal-to-noise ratio 10:1 | Confirmed by precision and accuracy |
| Resolution | 1.5 or greater | Typical system suitability target |
HPLC testing is an analytical technique used to separate, identify, and quantify components in a liquid sample. It relies on a pressurized mobile phase that carries the sample through a column packed with stationary phase. Different compounds travel at different rates because of interactions with the stationary and mobile phases. The resulting signal versus time is a chromatogram. Peak position indicates identity under specified conditions, while peak area or height relates to amount.
Laboratories apply HPLC testing across pharmaceutical, food, environmental, and industrial chemistry. The method can measure active ingredients, impurities, additives, preservatives, and degradation products. Sample preparation often includes dilution, filtration, and sometimes extraction or derivatization. The choice of column, mobile phase, pH, temperature, and detector depends on the analytes and matrix. Results are compared with reference standards to assign identity and concentration. Method suitability is judged by resolution, precision, and accuracy.
HPLC testing is not a single fixed procedure; it is a family of separation modes. Reversed-phase, normal-phase, ion-exchange, size-exclusion, and affinity chromatography each suit different analyte properties. Reversed-phase methods dominate because they handle many neutral and moderately polar compounds. Detection can be optical, electrochemical, or mass spectrometric, and the detector dictates what information is available. Coupling with mass spectrometry increases selectivity and enables identification when standards are unavailable. The technique cannot separate every mixture without adjustment.
Several separation modes exist, including reversed-phase, normal-phase, ion-exchange, size-exclusion, and hydrophilic interaction liquid chromatography. Reversed-phase uses a nonpolar stationary phase with a polar mobile phase and is widely applied to small organic molecules. Gradient elution changes mobile phase composition during the run, while isocratic elution keeps it constant. Column chemistry, particle size, temperature, flow rate, and mobile phase pH all influence retention and resolution. Method development selects conditions that separate analytes from matrix components and from each other.
Detection commonly uses ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. Ultraviolet detection depends on molecular chromophores that absorb light at specific wavelengths. Mass spectrometry provides mass information and sensitive quantification, often after electrospray ionization. Before sample batches, performance checks examine resolution, elution time repeatability, peak symmetry, and plate count. Matrix effects and co-elution remain recognized uncertainties; formal validation studies and orthogonal detection help address them. Detector choice depends on analyte properties and required sensitivity.
A number of studies of the effects of synephrine in humans, most of them focusing on its cardiovascular properties, have been performed since its introduction as a synthetic drug around 1930. The paper by Stockton and co-workers is representative, describing the effects of racemic synephrine in humans with particular attention to differences resulting from different routes of administration. Thus, it was shown by these investigators that intramuscular injections (average effective dose = 200 mg) of the drug produced an increase in systolic blood pressure and pulse rate, without affecting the diastolic pressure. The blood pressure increase reached a maximum (~25 mmHg) in 5 minutes following the injection, then gradually returned to normal over the course of 1 hour. Doses of drug greater than 200 mg caused side-effects such as heart palpitations, headache, sweating, and feelings of apprehension. When given intravenously, doses of 25–50 mg sufficed to produce a mean maximum increase in the blood pressure of 29 mmHg in 2 minutes, and a return to baseline within 30 minutes. Respiration was generally not affected during these experiments. Subcutaneous administration of synephrine in doses ≤ 200 mg had no effects on blood pressure or pulse rate. Oral doses of 500–1500 mg of the drug did not affect blood pressure or respiration, but pulse rate was increased by ~12%, and the highest doses caused nausea and vomiting. The i.m. administration of 75–500 mg of synephrine did not relieve acute asthma attacks, contradicting an earlier claim.
=== Serine === Serine is the first amino acid in this family to be produced; it is then modified to produce both glycine and cysteine (and many other biologically important molecules). Serine is formed from 3-phosphoglycerate in the following pathway: 3-phosphoglycerate → phosphohydroxyl-pyruvate → phosphoserine → serine The conversion from 3-phosphoglycerate to phosphohydroxyl-pyruvate is achieved by the enzyme phosphoglycerate dehydrogenase. This enzyme is the key regulatory step in this pathway. Phosphoglycerate dehydrogenase is regulated by the concentration of serine in the cell. At high concentrations this enzyme will be inactive and serine will not be produced. At low concentrations of serine the enzyme will be fully active and serine will be produced by the bacterium. Since serine is the first amino acid produced in this family both glycine and cysteine will be regulated by the available concentration of serine in the cell.
==== Black People's Convention ==== In August 1971, Biko attended a conference on "The Development of the African Community" in Edendale. There, a resolution was presented calling for the formation of the Black People's Convention (BPC), a vehicle for the promotion of Black Consciousness among the wider population. Biko voted in favour of the group's creation but expressed reservations about the lack of consultation with South Africa's Coloureds or Indians. A. Mayatula became the BPC's first president; Biko did not stand for any leadership positions. The group was formally launched in July 1972 in Pietermaritzburg. By 1973, it had 41 branches and 4000 members, sharing much of its membership with SASO.
Sources: en.wikipedia.org
In 2008, she co-founded Hepregen, based on her microliver technology for drug testing. Hepregen was acquired by BioIVT in 2018. In 2015, Bhatia spun off Glympse Bio based on her activity-based nanosensor technology. Glympse Bio received significant funding to advance "activity sensors" for diagnosis and therapy selection, completing safety studies in human volunteers before merging with Sunbird Bio in 2023. She has also co-founded other startups, notably Satellite Bio (microliver "satellite" technology with Christopher Chen), Port Therapeutics (along with Gabe Kwong and Mikhail Shapiro), Impilo Therapeutics (with Erkki Ruoslahti, Frank Slack, and Michael Sailor; the company was acquired by Lisata Therapeutics in 2020), Ropirio Therapeutics (with Christopher Chen), Matrisome Bio (with Richard Hynes), and Amplifyer Bio (with J. Christopher Love, Viktor Adalsteinsson, and Todd Golub). Bhatia is a passionate advocate for gender equity and inclusivity in STEM fields. She co-founded the MIT Faculty Founders Initiative with MIT Professor and President Emerita Susan Hockfield and MIT Amgen Professor of Biology Emerita Nancy Hopkins. This initiative aims to address the significant disparity in the number of female academics in science and engineering who become entrepreneurs. Their research revealed that women had founded less than 10% of the 250 biotech startups created by MIT professors, despite women comprising 22% of the MIT faculty. Her dedication to diversity extends to:
=== Psychological motivations === Psychology is another factor to take into consideration in doping in sport. It becomes a behavioral issue when the athlete acknowledges the health risks associated with doping, yet participates in it anyway. This has to do with the psychological thinking that the drug will make one feel invincible. The individuals are very egotistic in their way of thinking and their motivation is dependent on the performance enhancement drug since they believe that it delivers the results. On a study on health psychology, Quirk points out three different psychological aspects that lead one to dope: social cognition, stress and strain, and addiction. The social and physical pressures can alter an athlete's way of thinking, leading them to believe that they must take performance enhancement drugs since everyone else is doing it, known as "the doping dilemma." This also causes athletes to be hesitant to consult with a doctor about their steroid use, putting themselves at more risk with health problems.
=== Synonymous mutation of bases === When an incorrect nucleotide is inserted during replication or transcription of a coding region, it can affect the eventual translation of the sequence into amino acids. Since multiple codons are used for the same amino acids, a change in a single base may still lead to translation of the same amino acid. This phenomenon is referred to as degeneracy and allows for a variety of codon combinations leading to the same amino acid being produced. For example, the codes TCT, TCC, TCA, TCG, AGT, and AGC all code for the amino acid serine. This can be explained by the wobble concept. Francis Crick proposed this theory to explain why specific tRNA molecules could recognize multiple codons. The area of the tRNA that recognizes the codon called the anticodon is able to bind multiple interchangeable bases at its 5' end due to its spatial freedom. A fifth base called inosine can also be substituted on a tRNA and is able to bind with A, U, or C. This flexibility allows for changes in bases in codons leading to translation of the same amino acid. The changing of a base in a codon without the changing of the translated amino acid is called a synonymous mutation. Since the amino acid translated remains the same a synonymous mutation has traditionally been considered a neutral mutation. Some research has suggested that there is bias in selection of base substitution in synonymous mutation. This could be due to selective pressure to improve translation efficiency associated with the most available tRNAs or simply mutational bias.
Sources: en.wikipedia.org
Validation establishes suitability for a new method, while verification confirms that a method works in a specific laboratory. Verification is often used when a validated method is adopted with existing equipment and staff. Both rely on documented acceptance criteria.
Quantification usually compares detector response to a standard curve made from reference standards. The curve may be external, internal, or based on standard addition depending on matrix effects. Results are reported with units and, when required, uncertainty.
Carryover occurs when analyte from a previous injection remains in the system and appears in a later chromatogram. It can come from the injector, column, or tubing. Blank injections and needle washes help detect and reduce it.
HPLC testing measures the presence and amount of one or more compounds in a liquid sample. It separates mixture components and records detector responses as peaks, which are compared with reference standards. Results are usually reported as concentrations or relative percentages.