The short version of reference standard fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2025-12-07. Anything still debated is marked as such rather than presented as settled.
Practical HPLC testing depends on careful sample preparation and instrument maintenance. Samples may require filtration, dilution, pH adjustment, or extraction to avoid column damage and matrix interference. Mobile phases are degassed and filtered, and columns are equilibrated before injection. Common problems include peak tailing, baseline drift, ghost peaks, carryover, and co-elution of analytes. Documentation of instrument logs, calibration records, and electronic audit trails supports data integrity and traceability. Ongoing training and routine maintenance help reduce variability between analysts and laboratories.
Quality control laboratories use HPLC to check identity, purity, concentration, and stability of raw materials and finished products. A validated method specifies the column, mobile phase, flow rate, detection wavelength, injection volume, and run time. Samples are prepared and compared against reference standards of known concentration. The resulting chromatogram provides quantitative data, such as assay values and impurity levels. This approach is common in pharmaceutical, food, environmental, and industrial testing where consistent measurements are required.
Method validation evaluates accuracy, precision, specificity, linearity, range, detection limit, quantitation limit, and robustness. Regulatory guidance for pharmaceuticals, foods, and environmental testing defines expected documentation and acceptance criteria. Verification confirms that a validated method works in a specific laboratory with its own instruments and reagents. Calibration curves use reference standards with known purity and traceability, while measurement uncertainty is estimated from validation data, control charts, and collaborative studies. The scope of validation depends on the method's intended use.
Routine quality control monitors retention time shifts, baseline noise, system pressure, and peak shape. Trends can reveal column aging, mobile phase preparation errors, detector drift, or sample degradation. Corrective actions may include replacing the column, preparing fresh mobile phase, or recalibrating the detector. Stability testing often uses HPLC to measure parent compound loss and degradation product formation. Open questions remain about how accelerated stability results extrapolate to long-term storage under varied conditions.
Quality control for HPLC testing combines scheduled checks, documented procedures, and review of results. Before sample analysis, system suitability testing confirms that the instrument, column, and method meet predefined criteria. Common criteria include resolution between critical peaks, retention time precision, peak tailing, and theoretical plate count. Failure triggers investigation before results are reported. Records link raw data, calculations, instrument logs, and analyst identity to each batch, supporting audits and repeat analysis.
| Parameter | Typical acceptance criterion | Notes |
|---|---|---|
| Resolution | ≥ 1.5 | Baseline separation of adjacent peaks |
| Tailing factor | ≤ 2.0 | Peak symmetry measure |
| Theoretical plates | > 2000 | Column efficiency indicator |
| Injection repeatability | ≤ 2% RSD | Relative standard deviation for replicate injections |
| Linearity | r² ≥ 0.995 | Calibration curve over the working range |
Separation performance depends on particle size, pore size, column length, and the chemistry of the stationary phase. Smaller particles generally improve efficiency but require higher pressure and suitable instrumentation. The mobile phase often contains buffers and organic solvents that influence retention and selectivity. Testing labs select conditions based on the analytes, sample matrix, and required sensitivity. Method development frequently involves screening several columns and solvent mixtures before a final set of conditions is chosen.
High-performance liquid chromatography is an analytical technique that separates components in a liquid sample by passing them through a packed column under pressure. A pump delivers a mobile phase at a controlled flow rate, and an injector introduces the sample into the stream. Differences in how analytes partition between the mobile phase and the stationary phase cause them to exit the column at different times. Detection then records a signal proportional to the amount of each separated substance. The resulting chromatogram provides retention times and peak areas for identification and quantification.
Validation demonstrates that a method is suitable for its intended use. Typical performance characteristics include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Regulators and standards organizations provide frameworks, but specific requirements depend on the application and jurisdiction. System suitability tests are run before sample analysis to confirm resolution, peak symmetry, retention time repeatability, and sensitivity. A validated method is not permanently fixed; changes may require partial or full revalidation.
Routine HPLC testing depends on controlled reagents, calibrated instruments, and documented procedures. Columns degrade over time, so retention times and peak shapes are monitored for drift. Mobile phases are filtered and degassed to prevent pump damage and detector noise. Reference standards must be traceable and stored under suitable conditions. Data handling systems record injections, calculations, and audit trails. Quality control samples interspersed with unknowns help detect errors during a run.
High-performance liquid chromatography is an analytical technique that separates components in a liquid sample. A pump moves a liquid mobile phase through a column packed with a solid stationary phase. Compounds interact differently with both phases and travel at different rates, leaving the column at distinct retention times. A detector records these arrivals as peaks on a chromatogram. The resulting pattern supports identification and quantification of substances in mixtures. Modern instruments use high pressure to force solvent through small particles, which improves speed and resolution compared with older low-pressure liquid chromatography methods.
Separation in HPLC depends on the chemistry of the stationary phase, the composition of the mobile phase, and the physical properties of the column. Reverse-phase separations use a nonpolar stationary phase and a polar mobile phase, and they are common for many organic compounds. Ion-exchange, size-exclusion, and normal-phase modes serve other classes of analytes. Gradient elution changes solvent strength over time, while isocratic elution holds it constant. Flow rate, temperature, particle size, and column length all influence peak shape and resolution. Detection may use ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry, depending on the analyte and the required sensitivity.
'Dihydrogen monoxide' is a technically correct but rarely used chemical name of water. This name has been used in a series of hoaxes and pranks that mock scientific illiteracy. This began in 1983, when an April Fools' Day article appeared in a newspaper in Durand, Michigan. The false story consisted of safety concerns about the substance.
Five years later, GSK shuttered the Sirtris program without successful drug development. In 2006, Sinclair co-founded Genocea Biosciences, a company founded based on the work of Harvard scientist Darren E. Higgins around antigens that stimulate T cells and the use of these antigens to create vaccines; The company delisted from the NASDAQ and closed in 2022 due to lack of funding. In 2008, Sinclair was promoted to tenured professor at Harvard Medical School. A few years later, he also became a conjoint professor at the School of Medical Sciences at the University of New South Wales. In 2008, he also joined the scientific advisory board of Shaklee and helped them devise and introduce a product containing resveratrol called "Vivix". He later disputed the use of his name and words to promote the supplement, and resigned from the board. In 2011, Sinclair co-founded OvaScience along with Michelle Dipp, Aldrich, Westphal, and Jonathan Tilly. The company was based on scientific work done by Tilly concerning mammalian oogonial stem cells and work on mitochondria by Sinclair. The company merged with Millendo Therapeutics in 2018. In 2011, he also co-founded CohBar along with Nir Barzilai and other colleagues. CohBar aimed to discover and develop novel peptides derived from mitochondria. CohBar delisted from the NASDAQ upon belief that it was a public shell. In 2015, he co-founded Metro Biotech along with Washington University in St. Louis professor Dr. Rajendra Apte. The pharmaceutical company focused on NAD+ precursors such as NMN.
Gardner's proposed alternatives loosely follow the pleasant/good/meaningful life classifications outlined above; he believes young people should be trained to pursue excellence in their field, as well as engagement (see flow, above) in accordance with their moral belief systems.
== External links == International Chemical Safety Card 1313 Oregon Veterinary Medical Association (OVMA) Pet Food Contamination Page Archived 2008-10-20 at the Wayback Machine – News and developments updated regularly
Sources: en.wikipedia.org
In chemistry, there are three definitions in common use of the word "base": Arrhenius bases, Brønsted bases, and Lewis bases. All definitions agree that bases are substances that react with acids, as originally proposed by G.-F. Rouelle in the mid-18th century. In 1884, Svante Arrhenius proposed that a base is a substance which dissociates in aqueous solution to form hydroxide ions OH−. These ions can react with hydrogen ions (H+ according to Arrhenius) from the dissociation of acids to form water in an acid–base reaction. A base was therefore a metal hydroxide such as NaOH or Ca(OH)2. Such aqueous hydroxide solutions were also described by certain characteristic properties. They are slippery to the touch, can taste bitter, and change the color of pH indicators (e.g., turn red litmus paper blue). In water, by altering the autoionization equilibrium, bases yield solutions in which the hydrogen ion activity is lower than it is in pure water, i.e., the water has a pH higher than 7.0 at standard conditions. A soluble base is called an alkali if it contains and releases OH− ions quantitatively. Metal oxides, hydroxides, and especially alkoxides are basic, and conjugate bases of weak acids are weak bases. Bases and acids are seen as chemical opposites because the effect of an acid is to increase the hydronium (H3O+) concentration in water, whereas bases reduce this concentration. A reaction between aqueous solutions of an acid and a base is called neutralization, producing a solution of water and a salt in which the salt separates into its component ions.
A week later, after meeting Heseltine, the constituency officers issued another letter saying that they regretted how their reply had been construed as criticism. Then came Howe's resignation speech in the Commons on 13 November, in which he launched a strong attack on Thatcher; next morning Heseltine announced his candidacy for the leadership, saying that over 100 MPs had asked him to stand and that he was better placed than Thatcher to lead the Tories to a fourth election victory. During the subsequent leadership election on 20 November, he polled 152 votes (40.9%) in the first round of voting by Conservative MPs, enough to prevent an outright Thatcher victory. (The rules required an incumbent leader to obtain a majority of at least 15% on a first ballot; Thatcher polled 204 votes, equal to 54.8%). Heseltine was thought by many pundits to be on course to beat her in the second ballot as many Conservative MPs were now rumoured to be ready to switch support from Thatcher and only 27 would have had to have done so to give Heseltine the overall majority he would need in the second ballot. With lukewarm support from her Cabinet, most of whom had told her that she could not win and faced with the bitter prospect of a Heseltine premiership, Thatcher withdrew from the contest and announced her resignation on the morning of 22 November, although she continued to serve as prime minister until a new party leader had been chosen.
Hypothyroidism may be prevented in a population by adding iodine to commonly used foods. This public health measure has eliminated endemic childhood hypothyroidism in countries where it was once common. In addition to promoting the consumption of iodine-rich foods such as dairy and fish, many countries with moderate iodine deficiency have implemented universal salt iodization. Encouraged by the World Health Organization, 70% of the world's population across 130 countries are receiving iodized salt. In some countries, iodized salt is added to bread. Despite this, iodine deficiency has reappeared in some Western countries due to attempts to reduce salt intake. Pregnant and breastfeeding women, who require 66% more daily iodine than non-pregnant women, may still not be getting enough iodine. The World Health Organization recommends a daily intake of 250 μg for pregnant and breastfeeding women. As many women will not achieve this from dietary sources alone, the American Thyroid Association recommends a 150 μg daily supplement by mouth.
The cord is a unit of measure of dry volume used in Canada and the United States to measure firewood and pulpwood. A cord is the amount of wood that, when "ranked and well stowed" (arranged so pieces are aligned, parallel, touching and compact), occupies a volume of 128 cubic feet (3.62 m3). This corresponds to a well-stacked woodpile, 4 feet deep by 4 feet high by 8 feet wide (122 cm × 122 cm × 244 cm), or any other arrangement of linear measurements that yields the same volume. A more unusual measurement for firewood is the "rick" or face cord. It is stacked 16 inches (40.6 cm) deep with the other measurements kept the same as a cord, making it 1⁄3 of a cord; however, regional variations mean that its precise definition is non-standardized.
If on the other hand, the probe sequence encounters a target sequence with as little as one non-complementary nucleotide, the molecular beacon will preferentially stay in its natural hairpin state and no fluorescence will be observed, as the fluorophore remains quenched. The unique design of these molecular beacons allows for a simple diagnostic assay to identify SNPs at a given location. If a molecular beacon is designed to match a wild-type allele and another to match a mutant of the allele, the two can be used to identify the genotype of an individual. If only the first probe's fluorophore wavelength is detected during the assay then the individual is homozygous to the wild type. If only the second probe's wavelength is detected then the individual is homozygous to the mutant allele. Finally, if both wavelengths are detected, then both molecular beacons must be hybridizing to their complements and thus the individual must contain both alleles and be heterozygous.
Sources: en.wikipedia.org
Method validation is the documented process of confirming that an HPLC procedure is suitable for its intended use. It evaluates accuracy, precision, specificity, linearity, range, detection limits, and robustness. Validation criteria depend on the regulatory context and the sample type.
System suitability tests are short checks performed before or during an HPLC run to verify instrument and method performance. They often include resolution, tailing factor, theoretical plates, and injection precision. Results must meet predefined limits for sample data to be accepted.
HPLC retention time alone cannot definitively identify an unknown substance. A match with a reference standard under identical conditions provides supporting evidence. Confirmation typically requires mass spectrometry, nuclear magnetic resonance, or another orthogonal technique.
System suitability is typically performed before each batch or according to the validated method and laboratory procedure. Some long runs include periodic checks during analysis. The required frequency depends on regulatory expectations and method performance.